Brushless Esc V2.3 Manual ~upd~ Jun 2026

The is a common firmware version found in several brands of electronic speed controllers, including Towerpro Mag 8 and various generic waterproof 120A car ESCs. Standard Setup & Startup

: The ESC will cycle through a loop of beeps representing different menu items (e.g., 1 beep for Brake, 2 for Battery Type). Move the stick to neutral/bottom to select an item.

The red LED flashes repeatedly * - * - * . The ESC reduces power output to 50%, then cuts off power completely after 10 seconds to protect the battery.

Connect the three ESC wires to the three motor wires. If the motor spins the wrong way, swap any two of these wires. brushless esc v2.3 manual

Connects to the Positive terminal of your battery pack.

Enter programming: With ESC , turn on transmitter → full throttle → connect battery → wait for continuous beep cycle → move throttle to neutral to select menu.

Controls how much "kick" the motor has from a dead stop. High punch is great for racing but can lead to more wear on gears. 4. Maintenance for Longevity The is a common firmware version found in

System initialized successfully; no safety locks active.

Sets the voltage per cell at which the LVC activates (Off / 2.8V / 3.0V / 3.2V / 3.4V).

If you have made many changes and want to start over, you can reset the ESC to its factory default settings. The red LED flashes repeatedly * - * - *

The red and green LEDs flash together rapidly. The ESC cuts power instantly if the radio signal drops for more than 0.2 seconds. Troubleshooting Guide Potential Cause Resolution No power, LEDs dark Bad battery connection or broken switch

Negative (-) terminal. Connect to the negative lead of your LiPo/NiMH battery. Motor Output (Motor Side)