V2000-c Rfid Access Control User Manual Jun 2026
Always turn off the 12V DC power supply before splicing any wires to prevent short circuits. Lock Wiring:
Check your power supply output using a multimeter. Ensure the red wire is receiving a stable +12V DC current and the black wire is securely grounded.
The V2000-C is a 125KHz RFID standalone access control keypad designed for single-door security, supporting up to 1,000 users with card or PIN access. Programming involves entering a master code to add/delete users, configure door open times, and manage system settings. Official digital copies of the V2000-C User Manual are available at www.goldbridgesz.com V2000-c Rfid Access Control User Manual
The (often branded under Obo Hands or Youhe ) is a standalone RFID access control keypad used for single-door security. It supports up to 1,000 users and operates via 125KHz RFID cards, 4-digit PINs, or a combination of both. Quick Setup Guide
Enter Programming Mode -> Press 2 + 0000 + # . 4. Door Open Modes You can configure how users gain entry: Card Only: Press 3 + 0 + # . Card + PIN: Press 3 + 1 + # . Card or PIN (Default): Press 3 + 2 + # . 5. Setting the Door Delay Time Always turn off the 12V DC power supply
A: The access mode is determined by how you add the user. Using key 0 adds a user that requires both a card and a PIN (Card + PIN). Using key 2 adds a user that requires either a card or a PIN (Card or PIN).
The delay time determines how long the lock remains open after a valid entry. Enter Programming Mode. Press 4 + [00–99 Seconds] + # . Note: 00 sets the relay to toggle mode (latched). 6. Troubleshooting The V2000-C is a 125KHz RFID standalone access
Swipe the first card, then swipe the second card, then the third, and so on sequentially. Press # when finished, then press * to exit. Deleting Users Enter programming mode. Press 2 . Swipe the card you want to delete. Press # , then press * . Method B: Deleting by User ID (Essential if card is lost) Enter programming mode. Press 2 . Enter the target User ID (e.g., 0005 ). Press # , then press * .
The V2000-c is a standalone access control keypad that utilizes RFID card technology and a numeric keypad for secure entry. To ensure proper setup, please verify the following technical specifications: