| | Product | Solution | | :--- | :--- | :--- | | System does not detect the TS1162 | Tecom Keypad | Verify the model is set to TS1162 – 3 LED arming station in the programming software. If using a different bus format (e.g., Aperio EAC), ensure the Aperio EAC number is correctly entered. | | High contact resistance | Tactile Switch | Check for cold solder joints or insufficient solder. Reflow the terminals. Ensure the PCB pads are clean and free of oxidation. | | No signal after connecting | 3M Connector | Verify the connector is fully seated until the lock latch engages. Inspect for bent or damaged pins. | | Terrazzo surface is uneven | Terrazzo Flooring | Inadequate compaction during installation. Use a power roller for consistent density. Grind the surface with a coarse grit to level. |
After completing the installation, verify that:
: Wire a normally-open (NO) momentary button across the dedicated RTE input loop and ground. This triggers a door unlock cycle without creating an unauthorized entry alarm [1.12].
Slide the TS1162 drive canister into the dedicated library slot guide rails. Push smoothly until the drive docks firmly into the library’s backplane. ts1162 installation manual exclusive
A: No, it is powered directly by the , eliminating the need for a separate power source.
:
The key points to cover:
Set your laptop's Ethernet adapter to a static IP within the factory default subnet (typically 169.254.0.X or as specified in your accompanying documentation pack).
: The TS1162 includes a 2-meter pre-wired LiYY cable. If extending the cable, use a high-quality twisted, shielded pair for the RS-485 data lanes (D+ / D-). Avoid making tight wire loops inside adjacent junction boxes [1.11].
The following steps outline the installation procedure for the TS1162: | | Product | Solution | | :---
The describes the unit as a "Class-3 hermetically sealed interface." This means it is not a plug-and-play consumer device. It requires precise torque settings, specific cable shielding, and a grounding sequence that is unique to this model. The "exclusive" manual is often a 48-page industrial document, whereas the retail version is only a 12-page quick start.
: Power down the primary Challenger control panel and any auxiliary power supplies.
A: It is a 3-LED keypad with a Request-to-Exit (RTE) feature, used as a remote arming station for the . Reflow the terminals
What or panel type (e.g., Challenger10 vs ChallengerPlus) are you integrating this with?
Even with an exclusive manual, hiccups happen. Here’s the quick-fix list:
Job Alerts