/interface l2tp-server session print /ppp active print
Layer 2 Tunneling Protocol (L2TP) is a widely used protocol for creating virtual private networks (VPNs). In this article, we will provide a step-by-step guide on setting up an L2TP server on a Mikrotik router. This guide will cover the entire setup process, including configuration, authentication, and troubleshooting.
Similar steps using the built-in L2TP/IPsec VPN client. mikrotik l2tp server setup full
Before starting the configuration, ensure your MikroTik router meets the following requirements:
Enable the L2TP server and bind it to your WAN interface (or leave "default" to listen on all). /interface l2tp-server session print /ppp active print Layer
Common errors:
Setting up a L2TP VPN on a MikroTik Router - Natural Born Coder Similar steps using the built-in L2TP/IPsec VPN client
/ip ipsec peer add address=0.0.0.0/0 secret=YourStrongPreSharedKey generate-policy=port-override exchange-mode=main-l2tp send-initial-contact=yes
Then set the IPsec proposal:
If you run into connection failures, we can troubleshoot. Let me know: Your (v6 or v7?) What error code the client device shows If your router sits behind another ISP modem/NAT gateway
Administrative access to the router via Winbox or the WebFig interface.
