How To Fix A Insinkerator Garbage Disposal Hot Official

If it clicks and stays recessed, the circuit is reset. If it pops back out immediately, the motor needs more time to cool down. Step 4: Test the Disposal

Running the disposal dry causes high friction and rapid heat buildup. Always turn the cold water on before flipping the disposal switch.

Locate the small, hexagonal hole in the exact center of the bottom of the disposal housing under the sink. Insert the wrench into the hole. how to fix a insinkerator garbage disposal hot

Estimated cost ranges (US, approximate)

Allow the motor to cool for at least 15 to 20 minutes . If it is still hot to the touch, the reset may not take hold yet. If it clicks and stays recessed, the circuit is reset

by inserting the InSinkErator Jam-Buster™ wrench (or a 1/4-inch Allen wrench) into the center hole on the bottom of the unit.

You will need:

The first and easiest step is to reset the disposal's internal circuit breaker.

If you have cleared the jam, pressed the reset button, and allowed the unit to cool, but the disposal still gets hot, trips the breaker, or smokes, the internal motor has likely failed. A burnt-out motor or a worn-out internal seal that is leaking water into the electrical housing requires a replacement. InSinkErator units generally last 10 to 15 years, but if your unit is near the end of its lifespan, a replacement is often more cost-effective than repairing an out-of-warranty motor. Always turn the cold water on before flipping

Once these safety measures are in place, you can begin troubleshooting.

I can then tell you if it's a simple clog or if the